Stopping Transmission; Starting Transmission - Fujitsu Lifebook N5010 User Manual

cygnus.book Page 90 Tuesday, September 30, 2003 4:22 PM
L i f e B o o k N S e r i e s U s e r ' s G u i d e

STOPPING TRANSMISSION

To use this product inside hospitals, clinics, or airplanes,
or in other places where the use of electronic equipment
is regulated, stop the transmission of radio waves from
the wireless LAN beforehand.
Deactivation using the wireless switch
The transmission of radio waves from the wireless LAN
can be stopped by setting the wireless switch to the Off
position. Note that the Wireless LAN On/Off switch has
no effect on non-Wireless LAN models.
(See Figure 3 for Wireless LAN switch location.)
Figure 3. Wireless LAN On/Off Switch
90
Deactivation using Windows
1. Right-click the Wireless Network icon in the sys-
tem tray (it looks like a bar graph).
2. Click on Disable Radio. Wireless communications
on/off switching will be deactivated and the trans-
mission of radio waves from the wireless LAN will
be stoppe
d.
To restart transmission, check the [Enable
Radio] checkbox to select it., then click the
[OK] button.

STARTING TRANSMISSION

To communicate using the wireless LAN function, set
the computer to a status from which it can transmit, as
follows:
1. Click the Wireless Network Connection icon in the
system tray at the lower right of your screen.
2. Click [Enable Radio]. The radio will be turned on.
Access Point Mode: Transmission is enabled.
Ad Hoc Mode: Restart your computer to enable the
radio.