Fujitsu LifeBook T3010 Manual page 95

Problem
Unavailable It takes too long to
network
retrieve the network and
connection display the connected
(continued) computers.
Incorrect setting of IP
address
Access control may be
Communication
disabled
is disconnected
soon after
connection to the
access point
Possible Cause
Wireless LAN User's Guide
Possible Solution
Retrieve computers as follow:
1. Click [Start] button, then click [Search].
2. Click [Computers or people].
3. Click [Computers on the network].
4. Input the name of computer to be connected
with in [Computer name] and click [Search].
5. Double-click the icon of connected computer.
Check the network setting.
In case of using TCP/IP protocol, you can check
IP address as follows:
1. Click [Start] → [All programs] → [Accessories]
→ [Command prompt].
In [Command prompt] or [MS-DOS prompt]
window, input [IPCONFIG] command as
follows, then press [Enter] key.
Example: In case of C drive being the hard
disk: C:\ipconfig [Enter]
Check that the IP address is correctly
displayed:.
IP Address ................: 10.0.1.3
Subnet Mask.............: 255.255.255.0
Default Gateway.........: 10.0.1.1
When IP address is displayed as
[169.254.XXX.YYY] or [0.0.0.0],
IP address is not correctly fetched from the
access point. In that case, restar t the
computer itself. If the display is still
unchanged, check the setting of TCP/IP.
If [Cable Disconnected] or [Media
Disconnected] is displayed without showing
IP address, check the setting of network name
(SSID) and network key. Also, set the network
authentication according to the access point.
In case of Windows XP , check the setting of "Enable
network access control using IEEE 802.1X".
When restricting the access of wireless LAN
clients using IEEE802.1X authentication, put a
check mark on "Enable network access control
using IEEE 802.1X".
When using at home, remove a check mark on
"Enable network access control using IEEE802.1X".
For the method of setting related with
IEEE802.1X authentication, refer to the access
point manual.
83