Why You Should Connect This G-Link Cable; How To Find The Remote Sensor; Placing The G-Link Wands - RCA F20TF20, MR51TF20, F27TF700, MR68TF700 User Manual

Rca user's guide television f20tf20, mr51tf20, f27tf700, mr68tf700
Hide thumbs Also See for F20TF20, MR51TF20, F27TF700, MR68TF700:
Table of Contents

Advertisement

Why You Should Connect This G-LINK Cable

The G-LINK cable enables the GUIDE Plus+ system (the on-screen interactive program guide)
to work with your VCR and/or cable box.
Cable Box – If your TV is connected to a cable box you must connect the G-LINK cable to
receive TV program listings for your area, and to tune directly to a channel when the program
guide is on your TV screen.
VCR – If your TV is connected to a VCR and you don't connect the G-LINK cable, one-touch
VCR recording won't work. The other features of the guide will work properly.

How to Find the Remote Sensor

You have to place the G-LINK wands in front of the remote sensor on the VCR and/or cable box.
G-LINK cable
Some cable boxes and VCRs have the remote sensor labeled on the unit. If the remote sensor isn't
labeled on your VCR and/or cable box, you need to use the remote control that came with the VCR
and/or cable box to locate the sensor.
1. Turn off the VCR and/or cable box.
2. Hold the remote control (not the one that came with your TV, but the one that came with the
G-LINK wands
3. Slowly move the remote control across the front of the component (VCR or cable box) while
4. When the component turns on, you've located the remote sensor.

Placing the G-LINK Wands

Place the G-LINK wands in front of the remote sensor on your VCR and/or cable box approximately
one inch away from the remote sensor (see instructions below).
Tip
If you don't have both a
cable box and a VCR
connected to your TV, just
coil the cable of the extra
G-LINK wand with a twist
tie and leave it behind the
TV.
Chapter 1
cable box and/or VCR to which you're attaching the G-LINK cable) so that it is touching the
front of the component.
you press the power button on and off. You must press and release the power button each time
you move the remote (holding down the button won't work).
VCR
TV (back panel)
V-PORT
G-LINK
Connect to G-LINK jack
on the back of the TV.
Connections & Setup
VIDEO
R-AUDIO-L
Y
Pr
Pb
CABLE/
ANTENNA
VIDEO
R-AUDIO-L
R
L
From Cable,
Cable Box,
or Antenna
SENSOR
CABLE BOX
VCR
CHANNEL
SENSOR
03
CHANNEL
03
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents