Wolf 808744 Installation Instructions

8 0 8 7 4 4 - W o l f 3 0 ' ' ( 7 6 2 ) M i c r o w a v e T r i m K i t
TO AVOID ELECTRICAL SHOCK, SHUT OFF POWER BEFORE BEGINING INSTALLATION.
This kit includes metal parts that have sharp edges, handle with care to avoid possible injury.
NOTE: This Microwave trim kit is designed only for Wolf Microwave Ovens specifying 801527, 807056 or
808744 on rating label on the left side wall of oven cavity.
NOTE: Before begining remove turn table from microwave cavity.
CONTAINS: QTY DESCRIPTION
The Wolf Microwave Trim Kit (MWTRIM/5) is used only with the Wolf Microwave Model MW24. This model can
also be installed above a Wolf SO30.
The cabinet or wall opening must be the following dimensions:
INSTALLATION PROCEDURE:
1. Locate properly grounded 3-prong receptacle 4''
(102) from right side and 4'' (102) up from
bottom of microwave oven cabinet (See Cabinet
Dimensions).
NOTE: You must have a properly grounded, 3-
prong outlet installed by a qualified electrician. Do
not use a GFCI outlet, as this may cause product
operation interruptions.
2. The floor of the opening should be constructed of
plywood strong enough to support weight of oven
and floor load (about 100lbs./ 45 kg). The floor
should be level for proper operation of oven.
NOTE: Be sure to check local building code as it
may require that the opening be enclosed with
sides, ceiling and rear partition. The proper func-
tioning of the oven does not require the enclosure.
I n s t a l l a t i o n I n s t r u c t i o n s
1 Ductwork, MW24
2 Screw, #8-15x1/2 Truss Hd
1 Assemblied Trim Kit
6 6-18x1 Tpg Screw Type A
2 Trim, MW24 Polycarbonate
QTY DESCRIPTION
4 Self Tapping Screw - #8-18x1/2
1 Mtg Brkt, RT - MW
1 Mtg Brkt, LT - MW
1 Installation Instructions
Height: 17'' (432)
Width: 27-1/2'' (699)
Depth: 20'' (508) min.
Dimensions in brackets are in millimeters unless otherwise specified
Page 1 of 2
*1-1/4"
(32)
27-1/2"
(699)
*1-1/4
(32)
20" (508)
*17"
MIN.
(432)
MICROWAVE
PLATFORM
1" (2.5) MIN.
DECORATIVE
CABINET RAIL
1-1/4" (32) MIN.
* Dimensions may vary by +/- 1/8 (.3mm)
Cabinet Dimensions
808662 / Rev D / May, 2009