Connecting The Ac Adapter - Fluke 686 Getting Started

Connecting the AC Adapter

Connect the AC Adapter to the AC Adapter connector as shown in Figure 1.
The AC Adapter power cord must be connected to a power receptacle with
Earth Ground. Turn the power switch located on top of the instrument to ON.
You can now use your instrument while the battery is charging.
Before using the instrument without the AC Adapter, charge the
battery for about 3 hours.
Charge the battery or use the AC Adapter when the instrument displays a low
battery indicator on the status line just above the softkey labels. You can use a
fully charged battery for about 3 hours.
AC Adapter
Connector
TO HUB/MAU RJ - 45
Connector
TO HUB/MAU DB - 9
Connector
Figure 1. Network and AC Adapter Connectors (686/685 Shown)
18-28V
1.25A
+ -
TO HUB/MAU
NOT FOR CONNECTION TO PUBLIC TELEPHONE SYSTEMS
Enterprise LANMeter
Setting Up Your Instrument
Battery Charger
Status LED
BNC Connector
ON OFF
TO NIC
TO NIC RJ - 45
Connector
TO NIC DB - 9
Connector
5