Battery Replacement Notice - HP T750 G2 Installation Instructions

HP UPS R/T3000
WARNING: To prevent personal injury from electric shock
or damage to the equipment, remove the battery lead
labels, and verify that the ERM circuit breakers are in the
Off position.
1. Remove the UPS front bezel.
2. Disconnect the battery leads.
3. Remove the UPS battery bracket.
4. Remove the UPS battery modules.
IMPORTANT: Do not pull the battery leads when removing
or installing the batteries.
To replace the components, reverse the removal procedure.
HP UPS R5500
1. Remove the UPS front bezel.
2. Remove the UPS battery bracket.
3. Remove the UPS battery modules.
To replace the components, reverse the removal procedure.
HP 3 Phase UPS R8000/3 and
R12000/3
1. Remove the UPS front bezel.
2. Remove the UPS battery bracket.
3. Remove the UPS battery modules.
To replace the components, reverse the removal procedure.

Battery replacement notice

WARNING: Power products contain sealed lead-acid
battery modules. A risk of fire and burns exists if the
battery is not properly handled. To reduce the risk of
personal injury:
 Do not attempt to recharge the battery.
Do not expose the battery to temperatures higher than

60°C (140°F).
Do not disassemble, crush, puncture, short external

contacts, or dispose of in fire or water. The battery
might explode.
Batteries, battery packs, and accumulators
should not be disposed of together with the
general household waste. To forward them to
recycling or proper disposal, use the public
collection system or return them to HP, an
authorized HP Partner, or their agents.
For more information about battery replacement or proper disposal,
contact an authorized reseller or an authorized service provider.