Replacing the display assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Procedure
1
Slide the palm-rest assembly under the hinges of the display assembly.
2
Using the alignment posts, press the display hinges down on the palm-rest
assembly, aligning the screw holes on the display hinges with the screw holes on
the palm-rest assembly.
3
Connect the display cable to the system board.
4
Align the screw holes on the display-cable bracket with the screw holes on the
system board.
5
Replace the two screws (M1.6x2.5) that secure the display-cable bracket to
system board.
6
Connect the antenna cables to the system board.
The following table provides the antenna cable color schemes for the wireless
card supported by your computer.
Table 2. Antenna-cable color scheme
Connectors on the wireless card
Main (white triangle)
Auxiliary (black triangle)
7
Connect the camera cable to the system board, adhering the tape securing the
camera cable to the fans.
8
Align the screw hole on the wireless antenna and camera cable bracket to screw
hole on the system board.
9
Replace the screw (M1.6x3L) that secures the wireless antenna and camera
cable bracket to the system board.
38
computer. After working inside your computer, follow
After working inside your
computer. For more safety best
www.dell.com/
Antenna-cable color
White
Black
Before