Remote Control - RCA Pro809 User Manual

Remote Control

Install Remote Battery Cell
Pin Hole
1.
Back
of
Remote
1. Turn remote over and insert a pin or
straightened paper clip in the pin hole
to remove the battery holder.
2. Insert battery cell in battery holder so
positive (+) terminal faces up.
3. Replace battery holder.
Notes: Never place anything heavy on top of
the remote or lay it upside down.
Replace battery when camcorder fails to
respond to remote.
Remove the battery from the remote if it will
not be used for a month or more. This will
prevent possible damage from battery
leakage. If leakage occurs, wipe up the liquid
inside the compartment and replace
the battery.
Remote Sensor
The remote operates the camcorder by
infrared light, so it is protected from
electrical and sound interference.
However, the remote must be aimed
directly at the camcorder's remote
sensor. There cannot be any obstructions
between them.
Battery Cell Holder
2.
Lithium Cell Battery
With Positive (+)
Terminal Up
3.
Cautions: Lithium cell battery. Replace
only with Duracell No. DL2025. Use of
other cells may present a risk of fire or
explosion. Must be disposed of properly.
Never handle a punctured or leaking cell.
May cause burns or personal injury.
Keep out of the hands of children. Can
cause death or injury if swallowed. If
swallowed, consult a physician immediately
for emergency treatment.
The lithium cell used in this device may
explode resulting in a fire or chemical burn if
mistreated. Do not recharge, disassemble,
heat above 212˚F (100˚C), or incinerate.
Never use metallic tweezers to hold the cell,
and never short circuit the + and – sides of
the cell.
Remote Sensor
Note: The camcorder may not respond to the
remote control if the camcorder's remote
sensor is exposed to direct sunlight or strong
artificial light.
Replace
Battery
+
Cell
Holder
15