Cable Test - Denon AVR-S730H Troubleshooting Manual

Introduction How to operate
A
Question 8
Has your issue been fixed?
Yes
Please check
the Source/Monitor Device
(Note 3) or try Limit Mode
[Max Resolution/Deep Color]
(Note 4)

Cable Test

B C D
Question 4
Has your issue been fixed?
No
Question 9
Try Cable Test (Input side)
Do you want to limit
the video to deep color?
Yes No
Try Limit mode (Deep Color)
Set "Deep Color:Limit"
Question 10
Has your issue been fixed?
No Yes
Please check
Keep Please change
the Monitor Device
the Input Cable
the Limit Mode
Please try another video check again.
If your issue has been fixed, go to "Yes".
If you issue has not been fixed, go to "No".
(If you get the another Diag. ID, try another flow)
Yes
End
Question 11
Are the AV Receiver settings correct ?
Yes
Please call
Customer Service
Limit mode
E
Yes
No
Please connect the source device cable between HDMI1 IN
and MONITOR(1) OUT, then start the Cable Test.
What is the test result ?
4K(3G)-FAIL
CABLE TEST-PASS or
4K(6G)-FAIL
Question 5
If "4K(3G)-FAIL", do you want over 4K(3G) to be displayed?
If "1080P-FAIL", do you want over 1080p to be displayed?
If "720P-FAIL", do you want over 720p to be displayed?
Yes
No
Try Limit mode (Max Res.)
1) If "4K(6G)-FAIL", set "Max Res.:4K(3G)".
2) If "4K(3G)-FAIL", set "Max Res.:1080p".
3) If "1080P-FAIL", set "Max Res.:720p".
4) If "720P-FAIL", set "Max Res.:480p".
*Please change back to the original connection
from the "Cable Test" connection.
Question 6
Has your issue been fixed?
No Yes
Keep Please change
the Input Cable
the Limit Mode
(Note 3)
No
Please check the AV
Receiver setting.
(Note 2)
No
Please retry
setting the AVR
and try another video check.
35
Log & EDID Troubleshooting
F
CABLE TEST-FAIL
or 1080p-FAIL
Please change
the Output Cable