Assistance; Demo Mode - Indesit TIL642 Service Manual

5. ASSISTANCE:

5.1. DEMO MODE:

This mode makes it possible to use the touch panel normally without actually switching on the plates.
Access to Demo Mode
• To access DEMO mode press the TIMER button of plate F3, the TIMER button of plate F2 and the
ON/OFF button simultaneously and hold them down for 6 seconds. At this point the touch panel will be
activated and all the plates will be at level 0.
• When DEMO mode is active the 7-segment display will fl ash the message "DE" followed by "ON" at 10
second intervals.
Quitting Demo Mode
• To quit DEMO mode, press the plate F3 TIMER button and the ON/ OFF button simultaneously. The
7-segment display will show the message "DE" followed by "OF."
5.2. FAULTS TABLE:
ERROR CODES
Service Manual
Hobs - 2006
DESIGNATION
Power board error (Communi-
cation error or main board NTC
error)
Plate NTC error (this error
is possible only on induction
Hobs)
Interface board NTC error
Edition
2006.03.13
NOTE
Communication error: the two plates
connected to the part stop working.
NTC error: the 4 plates stop working.
The plate connected to the NCT stops
working
No plates working
Language
English
G
B
21