Indesit TIL642 Service Manual page 12

To modify the duration set previously, press the
button at the side of the display corresponding to
the cooking zone being used.
Press the and buttons to select the
“DURATION” option and press “OK” to confirm.
Adjust the minutes by pressing the
at the side of the display and press “OK” to modify
the time.
 During the setting process, press the
at the side of the display to reset the time value to zero.
To display the previously set function during the
cooking programme, press the
button at the side of the display corresponding to
the cooking zone being used. The display will show
the name of the active function and the remaining
time, if set.
 The power level of the cooking zone cannot be modified
while any of the CookEye functions are in operation.
®
 If the manual controls are not adjusted, the
automatic control maintains its temperature and both
the visual and sound alarms continue. If you do not
interrupt this automatic process within ten minutes,
the hotplate switches off.
 The buzzer may be stopped by pressing any
button on the hob.
 Do not use Cookeye with a lid over the cookware
®
or a utensil inside it (ladle, spoon, whisk, etc.). Make
sure that steam from the pan is not blown towards
the Cookeye lens, as this could disrupt its
®
“observation” function.
Switching off the Cookeye
Press and hold the red button for 3 seconds.
Alternatively, press the
the side of the display corresponding to the cooking
zone being used.
Press the and buttons to select the active
function and press “OK” to confirm.
Select the OFF option by pressing the
buttons at the side of the display and press the
“OK” button to stop the active function.
Clipso Eye function
Enables completely automated pressure cooking.
The Clipso Eye module should be used with the
Clipso Control pan to automatically regulate
Service Manual
Hobs - 2006
and buttons
and buttons
®
button at
and
pressure and to automatically switch the hotplate off
after the cooking programme has ended.
Starting the Clipso Eye function
 The Clipso Eye module can only be used with the
Clipso Control pan.
Infrared LED
On/Off button
1. Insert the Clipso Eye into the space provided in
the Clipso pan.
2. Switch on the hob and put the Clipso pan on one
of the two cooking zones at the rear right hand side
or the front left hand side of the hob..
3. Press the on/off button on the Clipso Eye.
4. The display shows “SELECT A COOKING ZONE”
and the 2 hotplate selection buttons at the side of
the display will flash at the same time.
5. Select one of the 3 cooking programmes on the
lid of the Clipso pan.
6. The display requests that a duration is set. Adjust
the minutes by pressing the
side of the display and press “OK” to confirm.
Cooking with Clipso Eye
Cooking will start
automatically once the
programme has been
confirmed. The power level
indicators for the relevant
hotplate will remain lit and the
following symbol will be
shown on the module display:
(see diagram).
Once the optimal pressure has been reached (the
pan releases steam) the timer begins to count down
automatically. At the end of the cooking programme,
the buzzer sounds and the hotplate switches off.
The Clipso Eye module remains active. For
instructions on how to switch it off, please refer to
the paragraph entitled “Deactivating the Clipso Eye”.
 The buzzer may be stopped by pressing any
button on the hob.
Edition
2006.03.13
and buttons at the
Language
English
G
B
12