Mount The Cover Plate And The Intake Grille; Handling For The Pipe Take-Off Part; Mount The Cover Plate (Right) - Fujitsu ABYA12-24LBTH Installation Manual

• Refrigerant address example
(Example) ADDRESS : 30
OPERATION
ON
indicator lamp
1.0s
1.0s
(Green)
OFF
TIMER ON
indicator lamp 0.5s 0.5s 0.5s 0.5s 0.5s 0.5s
(Orange)
OFF
ON
FILTER
indicator lamp
OFF
(Red)
• Setting details
Function
Item
number
01 Indoor unit address
02 Refrigeration address
For use with a remote controller, set all rotary switches to 0,
and refer to "7.1. Setting the address" for details.
All switches are set to 0 at the factory.
(2) Others
Indication pattern
Indicator Name
OPERATION Function number; tens place
indicator lamp (Green) (0.5s ON/0.5s OFF)
TIMER Function number; ones place (0.5s
indicator lamp (Orange) ON/0.5s OFF)
FILTER Setting number: (0 - 9) (0.5s ON/0.5s
indicator lamp (Red) OFF)
(Example) Function : 31, Setting number : 2
OPERATION
ON
indicator lamp
0.5s 0.5s 0.5s 0.5s 0.5s 0.5s
(Green)
OFF
ON
TIMER
indicator lamp 0.5s 0.5s
(Orange)
OFF
ON
FILTER
0.5s 0.5s 0.5s 0.5s
indicator lamp
OFF
(Red)
1 cycle 12 sec
1.0s 1.0s 1.0s
1.0s 1.0s
9 sec
OFF
Setting number
00~63
00~99
Indication pattern
1 cycle 12 sec
9 sec
11 sec
10 sec
8. MOUNT THE COVER PLATE AND
THE INTAKE GRILLE
] 1

8.1. Handling for the pipe take-off part

When the pipe is pulled out in the direction shown in the fi gure
below, cover the take-off part with material (putty or the like)
that will block it off.
UNDER CEILING TYPE
FLOOR CONSOLE TYPE
] 1

8.2. Mount the cover plate (Right)

(1) Cut a pipe exit hole in the right plate. This is only when
the pipe exits from the right side. (This operation is not
required when the protrusion is on the top or rear.)
Cover plate (Right) (Accessories)
Top
Rear
Right
En-19