Table of Contents
Advertisement
6
Capacity/Charging Problems
•
Make a general visual inspection for oxidation or corrosion from liquid damage
according to point 1.2.
6.1
Charging
•
Insert a working battery and connect a working charger to the phone. If the battery
voltage is too low, you must charge the battery without turning on the phone (this will
usually take less than 10 minutes) and when the battery voltage is high enough the phone
will be able to turn on and show charging in the display.
•
Check that the system connector (Fig.5.1) is incorrectly soldered, not mechanical
damaged, dirty or oxidized. Replace it if necessary.
If the failure still occurs, handle the unit according to the local company or the GSP
directives.
6.2
Capacity
•
The standby time will be reduced if the backlight is turned on all the time, or if the
infrared port is turned on.
4/00021-1/FEA 209 544/81 A
Sony Ericsson Mobile Communications AB
Fig.5.1
Trouble shooting Guide, SP/Mechanical
9(17)
Advertisement
Table of Contents
