Scenes - ABB 2CSYK1102C/S Product Manual

MYLOS Building Automation
®
2.5

Scenes

The scene function is enabled in the "Function" parameter window.
Scene values can be set (stored) over the bus. In the "General" parameter window you can determine that the values
set in the ETS are transferred in the Switch Actuator during download. In this mode the values stored in the terminal
are overwritten and lost.
"Associate output with (Scene 1...63)" parameter
The output can be associated with 63 different bright scenes using a group address.
The output can be associated with 5 bright scenes as a slave output.
Options:
- no scene
- Scene 1
- ...
- Scene 63
"Standard value" parameter
Here you set the status that the output assumes when the scene is recalled.
Options:
- ON
- OFF
When a scene is stored, the user has the possibility to modify the value that has been parametrised
here. The stored scene values are lost if the bus voltage fails. The values programmed in the ETS are
recovered upon bus voltage restoration.
Note: When a scene is recalled
- the time functions start from scratch
- the logic operations are evaluated again
20 Commissioning | MYLOS Building Automation
®
Commissioning