Controlling General Audio - Kenwood DDX9705S Instructions Manual

[Tweeter] (Only for Front)
■
You can set up the tweeter when you are
selecting front speakers.
None, Small, Medium, Large
[X over]
■
Display the speaker crossover setup screen.
You can adjust the crossover frequency that
was set automatically when you selected the
speaker type.
For details, see Crossover network setup
(P.79)
Ñ
Crossover network setup
You can set the crossover frequency of
speakers.
1
Touch [X over].
2
Touch the speaker to set up.
3
Set each parameter as follows.
[HPF FREQ]
■
High Pass Filter adjustment. (When Front or
Rear is selected on the Speaker Select screen)
[LPF FREQ]
■
Low Pass Filter adjustment. (When
Subwoofer is selected on the Speaker Select
screen)
1
■ [Slope]*
Set a crossover slope.
■ [Gain]
Adjust the gain of the front speaker, rear
speaker, or subwoofer.
[TW Gain] *
2
■
Adjust the tweeter level. (When Front is
selected on the Speaker Select screen)
[Phase Inversion]*
■
Set the phase of subwoofer output.
Check [Phase Inversion] to shift the phase
180 degrees. (When Subwoofer is selected
on the Speaker Select screen)
* 1 Only when "LPF FREQ"/"HPF FREQ" is set to
a mode other than "Through" in [X over].
* Only when "Tweeter" is set to "Small",
2
"Medium", "Large" in [Speaker Setup].
* Only when "Subwoofer" is set to a mode
3
other than "None" in [Speaker Setup].

Controlling General Audio

1
Press the [MENU] button.
h Popup menu appears.
h
2
Touch [Audio].
h Audio screen appears.
h
3
Touch [Fader / Balance].
4
Set each parameter as follows.
[Fader / Balance]
■
Adjust the volume balance around the
touched area.
[C] and [D] adjust the right and left volume
balance.
[R] and [S] adjust the front and rear volume
balance.
■ [Center]
Clear the adjustment.
Controlling Audio
3
English
79