Controlling Audio; 3-Way Speaker System Setup - Kenwood DMX1037S Instruction Manual

Controlling Audio

You can adjust various settings such as audio
balance or subwoofer level.
1
Press the [HOME]/[ ] button.
2
Touch [ ].
3
Touch [Audio].
See the following section for each
setting.
• Set up Speaker / X'over (P.68)
• Controlling EQ / SW Level (P.69)
• Set Position / DTA (P.70)
• Controlling FAD / BAL / Zone (P.72)
• Set Volume Offset (P.74)
• Set Sound Effect (P.74)
• Use Audio Memory (P.78)
NOTE
• When the iDatalink (commercially available)
is connected, the best audio settings are set
automatically.
Each parameter as follows are set.
– Speaker / X'over
– EQ / SW Level
– Position / DTA
– FAD / BAL / Zone
– Sound Effect
• To recall the settings automatically adjusted by
the iDatalink connection when the settings are
changed manually, touch [Audio SETUP Clear]
in the Audio Memory setting menu. (P.78)

3-way speaker system setup

(DMX1057XR)
Select the appropriate crossover network
mode for the speaker system used (2-way or
3-way speaker system).
# CAUTION
• Connecting 3-way speakers with the 2-way
mode selected can break the speakers.
1
Press the [HOME]/[ ] button.
h HOME screen appears. h
2
Touch [
].
h Source selection screen appears.
h
3
Touch [STANDBY].
4
Press [ ] button 1 followed by the
[HOME]/[ ] button 2 for 1 second at the
same time.
2
h Speaker system select screen appears.
h
5
Select the crossover network mode.
h A confirmation screen appears. h
6
Touch [Yes].
Controlling Audio
1
67
English