Table of Contents
Advertisement
Instruction Manual
D103803X012
Figure 11. Install the Handwheel
Hand Lever
6. Position the mounting bracket onto the body. Use copper-based anti-seize lubricant on the bracket studs and nuts.
Make sure the markings on the studs and nuts are facing out. Leave the nuts finger tight.
7. Insert the bracket bushing into the allotted slot of the mounting bracket.
8. Mount the stem adaptor on top of the stem with the two keys. Make sure it fits onto the stem easily without
hammering. Make sure the mark is facing the lapped side of the ball/end adaptor.
Figure 12. Stem Adaptor
9. Place the lock plate on top of the mounting bracket. Note the orientation of the open "O" and closed "C"
markings.
Z500 Valve
February 2014
15
Advertisement
Table of Contents
