Chapter 3: Nmea/Seatalk Connections; Raystar 120/112Lp - Nmea Versions; Using The Moulded 6-Pin Nmea Connector - Raymarine Raystar 112LP Owner's Handbook Manual

Chapter 3: NMEA/SeaTalk Connections

Chapter 3: NMEA/SeaTalk Connections
The sections in this chapter explain how to connect the NMEA and
SeaTalk versions of the Raystar 120/112LP to other equipment:
Section
Section 3.1, Raystar 120/112LP - NMEA versions
Section 3.2, Raystar 120/112LP - SeaTalk versions
Section 3.3, Using a connector block

3.1 Raystar 120/112LP - NMEA versions

Note: As with all on-board marine equipment, you must ensure that the
power supply connection to the Raystar 120/112LP is adequately
protected by a suitably rated fuse or circuit breaker. Usually this will be
achieved by providing power via a fused display unit.

Using the moulded 6-pin NMEA connector

The unit is normally connected to an NMEA system via the 10 m (33 ft)
cable terminated with a moulded 6-pin connector (see Figure 3-1). Use
this connector if your equipment has a compatible GPS port.
NMEA connector
Figure 3-1: NMEA connector pin-outs
3 Screen (0 V/ground)
2 Screen
(0 V/ground)
1 Red
(Power )
6 Brown (RTCM in)
11
Page
11
12
13
4 Yellow
(NMEA out)
5 Green
(NMEA in)
D5899-1