Assembly - Delta HOMECRAFT H26-260L Instruction Manual

• Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration
or modification is misuse and could result in a hazardous condition.
• Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting.
• Do not start the miter saw without checking for interference between the blade and the miter fence. Damage could
result to the blade if it strikes the miter fence during operation of the saw.
• This saw can tip over if the saw head is released suddenly and the saw is not secured to a work surface. ALWAYS
secure this saw to a stable work surface before any use.
• If any parts are damaged or missing do not operate this tool until the parts are replaced. Please call Customer Care
Center at 800-223-7278, for instructions.
1. The saw is shipped with the arm secured in the
down position as shown in Figure 2. To release
the arm, push it down, cut the plastic tie and
release the lock pin (A).
2. Inspect the tool carefully to make sure no
damage occurred during shipping.
3. Do not discard the packing material until you
have carefully inspected and satisfactorily
operated the tool.
4. See Figure 3 and attach the miter lock knob by
screwing the end of the miter lock handle (A) into
the threaded hole (B) in the control arm. Tighten by
rotating the lock knob clockwise

ASSEMBLY

FIGURE 2
FIGURE 3
9
A
7
6
5
4
3
2
1
B
A