Raymarine autopilot + ST4000+ Owner's Handbook Manual page 80

Chapter 5: Installing the ST4000+
Cantilever mounting
If you need to attach the tiller drive to a vertical face (such as the
cockpit sidewall), use a Raymarine cantilever socket assembly
(part number D031):
•
•
Cutting the cantilever rod to length
1. Clamp the tiller on the boat's center line.
2. Measure dimension F (actual).
3. Refer to the table to establish a cutting length for the cantilever
4. Measure the rod from threaded end, then cut the cantilever rod
Dimension F
686 mm (27 in)
711 mm (28 in)
737 mm (29 in)
762 mm (30 in)
787 mm (31 in)
813 mm (32 in)
838 mm (33 in)
'B'
90 degrees
the maximum possible extension offset is 254 mm (10 in)
you cut the cantilever to the exact length during mounting
rod – double check measurements before cutting.
to length L using a hacksaw. Remove any sharp edges with a file.
Cut length L
51 mm (2 in)
75 mm (3 in)
102 mm (4 in)
127 mm (5 in)
152 mm (6 in)
178 mm (7 in)
203 mm (8 in)
65
D309-2