Connecting To The Control Unit - Raymarine autopilot + ST4000+ Owner's Handbook Manual
Raymarine wheel & tiller autopilot owner's handbook st4000+
Hide thumbs
Also See for autopilot + ST4000+:
- Owner's handbook manual (130 pages) ,
- Service manual (34 pages) ,
- Quick reference (3 pages)
Table of Contents
Advertisement
58
4. Making sure the cable exits at the bottom of the compass, secure
Note: Stick the supplied warning label near to the compass, where it
is clearly visible.
Connecting to the control unit
1. The compass is supplied with 8 m (26 ft) of cable. Route the cable
Note: Make sure you leave some spare cable so, if necessary, you can
re-position the compass to reduce deviation. If the standard cable is
not long enough, your Raymarine dealer can supply a 10 m (30 ft)
extension cable (part number: D174).
2. Connect the five cores of the cable as shown to the Compass
ST4000+ Wheel & Tiller Autopilots: Owner's Handbook
the fluxgate compass using the self-tapping screws provided
3
(No 8 x
/
in, pan-head).
4
to the control unit, taking into account the EMC installation
guidelines (page 46).
terminals on the control unit.
Blue
Yellow Green
Red
Screen
D3282-2
Hide quick links:
Advertisement
Table of Contents
