Mounting Procedure - Raymarine autopilot + ST4000+ Owner's Handbook Manual

Chapter 5: Installing the ST4000+

Mounting procedure

Control units are available in surface mount and flush mount styles.
Surface mount control units
To fit a surface mount control unit:
1. Apply the surface mount template (supplied at the back of this
2. Mark the centers of the two fixing holes and the cable boss.
3. Drill two 5 mm (
4. Use a 90 mm (3.55 in) diameter cutter to drill the hole for the
5. Peel the protective sheet from the self-adhesive gasket, then stick
6. Screw the fixing studs into the control unit.
7. Pass the cables (power, compass, SeaTalk etc.) through the
8. Assemble the control unit to the bulkhead.
9. Secure the control unit with the thumb nuts provided.
handbook) to the selected bulkhead.
3
/ in) diameter holes for the fixing studs.
16
cable boss.
the gasket into position on the rear of the control unit surround.
bulkhead and connect them to the appropriate terminals (as
described later in this chapter).
Hand-tighten the thumb nuts – do NOT use a wrench.
49