Table of Contents
Advertisement
2 SYSTEM CONFIGURATIONS
2 SYSTEM CONFIGURATIONS
2.1 Applicable System
2
2 - 1
This chapter explains the system configuration of the QD62 (E/D).
This section explains the applicable system.
(1) Applicable CPU and number of modules that can be mounted
The CPU module and network module (for remote I/O station) that can have the
QD62 (E/D) and the number of modules that can be mounted are listed below.
Applicable module
Q00JCPU
Q00CPU
Q01CPU
Q02CPU
Q02HCPU
CPU module
Q06HCPU
Q12HCPU
Q25HCPU
Q12PHCPU
Q25PHCPU
QJ72LP25-25
QJ72BR15
Network module
QJ72LP25G
QJ71LP25GE
1 See User's Manual (Function Explanation, Program Fundamentals) for the CPU module to use.
2 See Q Corresponding MELSECNET/H Network System Reference Manual (Remote I/O
network).
(2) Mountable base unit
QD62 (E/D) can be mounted on any of the base unit's I/O slots ( 3). However,
depending on combinations with other mounted modules and the number of
mountings, there may be cases where the power capacity is insufficient. Be sure
to consider the power capacity when mounting the module.
3 Must be inside the point number range of 1 CPU unit and network module
(for remote I/O station).
(3) Compatibility with a multiple PLC system
First read the QCPU (Q mode) User's Manual (Function Explanation, Program
Fundamentals) if the QD62 (E/D) is used with a multiple PLC system.
(a) Compatible QD62 (E/D)
In case of using the QD62 (E/D) with the multiple PLC system, there is no
restriction by the version.
(b) Intelligent function module parameters
Perform PLC write of the intelligent function module parameters to the
control PLC of the QD62 (E/D) only.
Number of modules that
can be installed
Maximum 16
Maximum 24
Can be installed in Q mode only
Maximum 64
1
(
)
Maximum 64
MELSECNET/H Remote I/O
Maximum 64
station (
MELSEC-Q
Remarks
1
(
)
1
(
)
2
)
2 - 1
Advertisement
Table of Contents
