Napoleon NEFBD50H Installation And Operation Manual page 20

operating instructions
EN
Ember Bed Color
Flame Speed
Temperature
Control
Heater
Timer
note:
When only the heat is on (i.e. no flames, no ember bed lights, etc.), the display window will be dim and show H1
as the status.
After the heater is turned off, the blower will continue running for 1 minute. This helps to remove heat and bring
down the temperature of the appliance.
20
W415-1767 / B / 11.23.17
Controls ember bed light settings.
Settings:
C1 - Orange
C2 - Red
C3 - Blue
C4 - Yellow
C5 - Green
C6 - Purple
C7 - Sky Blue
C8 - Magenta
C9 - White
C10 - Pink
C11 - Cycle through C1 to C10
C12 - Lock a color during C11 cycle.
Controls flame speed.
There are 5 flame speed settings: S1 to S5. S1 is the slowest
setting and S5 is the fastest setting.
Sets desired temperature. There are 11 temperature settings:
64ºF [18ºC]
66ºF [19ºC]
68ºF [20ºC]
70ºF [21ºC]
72ºF [22ºC]
74ºF [23ºC]
76ºF [24ºC]
78ºF [25ºC]
80ºF [26ºC]
82ºF [27ºC]
and OFF
To switch from ºC to ºF or ºF to ºC, hold the temperature con-
trol button for 5 seconds.
Turns the heater and blower on/off.
Settings:
OFF - Heater and blower off
BL - Blower on
H1 - Heater on (1500W @ 120V and 3000W @ 240V)
H- - Heater and thermostat disabled
(Press and hold the heater button for 5 seconds to disable /
re-enable the heater and thermostat).
Each side of the appliance has an independent heater control.
Sets the timer.
There are 9 timer settings: 0.5h, 1h, 2h, 3h, 4h, 5h, 6h, 7h, 8h