Operation - Craftsman 247.88790 Owner's Manual

Read this owner's manual and safety rules before operating your snow thrower. Compare Figure 7 below with your
snow thrower to familiarize yourself with the location of various controls and adjustments. Save this manual for
future reference.
Headlight
Fuel Tank
Chute Assembly
Clean-Out Tool
Shave Plate
Auger
Operating Controls
(See Figure 7 )
Drive / Auger Control Lock
The drive control is located on the right handle.
Squeeze down the drive control to engage the wheel
drive. Release to stop.
The drive control also locks the auger control so you
can operate the chute directional control without
interrupting the snow throwing process. If the auger
control is engaged simultaneously with the drive
control, the operator can release the auger control (on
the left handle) and the augers will remain engaged.
Release both controls to stop the augers and wheel
drive.
IMPORTANT: Always release the drive control before
changing speeds.

OPERATION

Carburetor
Cover
Ignition
Key
Choke
Throttle
Control
Skid Shoe
Figure 7
Auger Control
The auger control is located on the left
handle. Squeeze the auger control to
engage the augers. Release to stop the
snow throwing action. The drive control
must also be released in order to stop
the auger.
IMPORTANT: Refer to Auger Control Test on page 6 prior
to operating your snow thrower. Read and follow all
instructions carefully and perform all adjustments to
verify your snow thrower is operating safely and
properly.
Ignition Key
The ignition key must be inserted and snapped in place
in order for the engine to start. Remove the ignition key
to prevent unauthorized use of equipment. Do NOT
attempt to turn the key.
8
Drive Control
Shift Lever
Four-Way
Chute Control™
Auger Control
Wheel Steering
Control
Oil Fill
Muffler
Spark Plug
STO P
Oil Drain
Fuel Cap
Electric
Starter
Starter
Handle
Primer