Excluding (Deleting) Z-Wave Devices; Icons; Excluding An Existing Device - Honeywell Tuxedo Touch Manual

Step-by-Step

Icons

Excluding an Existing Device

- Upon pressing the (Exclusion Icon) the screen will display the following message: "Start remove
device. Please press function key on device."
- The next step is to press the program button or code on the device to remove. Refer to trouble shooting
for "Action Failed" message is displayed.
- This means the device did not receive the default command to remove it from the Tuxedo's network
- This is also useful for removing a device that was enrolled on a previous network. See troubleshooting
for more information.
Example: To remove a ZWSTAT from the network, perform the following steps:
- Press the "Exclude"(enrollment) button on the "Node" (see node instructions)
- Example: Using the Honeywell Zstat you would press the Up Arrow at the rF10 prompt in
programming:
Back to Table of Contents

Excluding (Deleting) Z-Wave Devices

Delete (Exclude) Device (Node) Icon
Abort Operation Icon
Delete Device (Node) Icon
- 17 - Updated: 4/20/12