Weber Genesis 330 Owner's Manual page 10

Installation Outside of Cabinet
If the cylinder you have does not meet the cylinder type and size guidelines: Mount
the cylinder on the cylinder hanger or place the cylinder on the ground . Either way the
cylinder must be placed outside the base cabinet, on the right side of the grill .
Cylinder Hanger Installation
You will need: the cylinder hanger bracket (1) and cylinder hanger (2) .
A) Position the cylinder hanger bracket on the right outside panel of the grill . Fasten
with screws, washers and nuts (3) .
B) Install the cylinder glides (4) into the two holes below the cylinder hanger bracket .
Fasten with screws, washers and nuts .
C) Turn the cylinder so the valve opening faces the front of the barbecue .
D) Hold the cylinder hanger and tilt the cylinder so the two bent supports of the
cylinder hanger are located underneath the cylinder base flange. Adjust the length
of the belt to the cylinder, and snap ends together (5) .
E) Lift and place the cylinder hanger on the cylinder hanger bracket as shown (6) .
Ground Placement
A) Place the cylinder on the ground, outside the base cabinet, on the right side of the
grill (7) .
B) Turn the LP cylinder so the opening of the valve is facing the front of the Weber
barbecue .
◆
The grill illustrated may
have slight differences
than the model purchased.
10
GAS INSTRUcTIONS
®
7
1
3
gas
4
2
5
6