Programming Favorite Channel Scan - Radio Shack Light and Learn Remote Owner's Manual

4. Hold down until the remote's red light blinks
P
twice, then enter the first 4-digit manufacturer's
code for the desired device. When the red light
blinks twice, the remote control has accepted the
code.
For example, to set up the remote control of a
Panasonic TV (manufacturer's code 0051), press
, hold down until the red light blinks twice,
TV P
then press .
0 0 5 1
Note: If you entered the code incorrectly, the red
light emits one long blink.
5. Point the remote control at the desired device and
press . The device should turn off.
POWER
If the remote control does not operate your
device, try the other codes listed in "Manufactur-
ers' Codes" on Page 25 for your brand of device.
Otherwise, use the search method to find a work-
ing code (see "Using Manual Code Search" on
Page 23).
6. Repeat Steps 2–5 to program other devices.
Note: If the remote control does not operate all
device functions, try using another code in the list
that may be more compatible.
PROGRAMMING FAVORITE
CHANNEL SCAN
Once you have programmed channels into a favorite
channel table, you can scan up to ten favorite chan-
nels for a desired device.
Note: Once you have programmed
vorite Channel Scan, you cannot use it for Channel
Scan unless you reset it (see "Resetting Scan").
1. Select or
TV CBL/SAT
scan.
2. Hold down until the red light blinks twice.
P
3. Press . The red light blinks twice.
9 9 6
10
Preparation
for Fa-
SCAN/FAV
for the favorite channel