RS 4in1 Kam User Manual.fm Page 11 Friday, March 4, 2005 9:09 AM
2.
Press and hold P until the IR segment
flashes twice.
3.
Using the number keys, enter 9 9 6. The
IR segment will flash twice.
NOTE: If the IR segment displays one
long flash, an error has occurred. Try
repeating this step.
4.
Using the number keys, enter a favorite
channel number (e.g., 0 1 2). Then press
P. The IR segment will flash three times
confirming your entry.
NOTE: If the original remote control
required pressing an ENTER key to change
the channel, also press the ENTER key
after the channel number (e.g., 0 1 2
ENTER).
NOTE: If you try entering more than 10
channels, or if more than 10 seconds
elapse between key presses, the remote
automatically exits programming.
5.
If desired, repeat step 4 for each channel
to be stored, up to a total of 10 channels.
NOTE: After storing 10 channels, the
remote control will exit Favorite Channel
programming.
6.
To exit programming with less than 10
favorite channels stored, press and hold
P until the IR segment flashes twice.
NOTE: If you have entered less than 10
favorite channels and wish to add more,
you will need to re-enter all of the
channels.
NOTE: If you have programmed 10
favorite channels, you will need to reset
the remote to program new channels. See
"Troubleshooting" on page 14.
O
WNER
USING CHANNEL SCAN
In all modes, press the SCAN key to start a 3-
second scan of all channels. If programmed,
press the FAV SCAN key to scan only your
favorite channels to view a desired channel
(see "Programming Favorite Channel Scan"
on page 10).
Press VCR, DVD, CBL/SAT, or TV. The IR
1.
segment flashes once as the selected
device key animates.
2.
Press FAV SCAN. The IR segments will
display outgoing animation as each
channel is changed.
•
If Favorite Channel Scan has been
set up, scanning of favorite
channels will start and cycle
through stored channels for
3minutes or until stopped by
pressing any key.
•
If Favorite Channel Scan has not
been set up, scanning will start
with the current channel, then
proceed to the next channel up and
cycle through all channels for 3
minutes or until stopped by
pressing any key.
3.
To stop scanning channels at any time,
press any key.
REASSIGNING DEVICE KEYS
The RadioShack 4-in-One Remote can be set
to control a second device. For example, to
control a TV, a cable box, and two DVD
players, you can reassign an unused VCR key
to operate the second DVD player as follows:
1.
Press and hold P until the IR segment
flashes twice.
2.
Using the number keys, press 9 9 2. The
IR segment flashes twice.
Using Channel Scan
'
M
S
ANUAL
11