Mixed Original Size Adjustment - Konica Minolta bizhub C754E Installation Manual

XXIV. Mixed original size adjustment
Note:
Perform this adjustment if necessary.
1. Display the Service Mode screen.
(For details of how to display the Service Mode
screen, see the service manual.)
2. Touch "ADF."
3. Touch "Mixed original size adjustment."
4. Place the chart in the document feeding tray
(lengthwise).
5. Press the Start key.
6. Check that "Adjustment Result" is "OK."
7. Touch "END."
XXV. Adjusting the document stop posi-
tion
<Sub Scanning Direction 1-side/ Sub Scanning
Direction 2-side>
Note:
Perform this adjustment if necessary.
1. Place the chart in the document feeding tray (with
the side having an arrow facing up).
2. Make a single-sided copy sample in full size.
3. Place the chart in the document feeding tray.
(Make sure that the blank surface of the chart
faces up.)
4. Make a duplex copy sample in full size.
5. Check whether the difference in the width B
between the chart and the copy sample is within
the specified range.
Difference in the width B = B of the copy sample –
B of the chart
Specifications: 0 ± 2.0 mm
A2X0IXC041DA
* If the difference in the width B does not fall within
the specified range, perform the following
adjustment.
6. Display the Service Mode screen.
(For details of how to display the Service Mode
screen, see the service manual.)
7. Touch "ADF."
8. Touch "Original Stop Position."
9. Touch "Sub Scanning Direction 1-Side" or "Sub
Scanning Direction 2-Side."
10. While looking at the copy sample, enter a value
using the ten-key pad on the touch panel. (To
switch the signs, press the +/- key.)
Adjustable range: -4.0 mm to +4.0 mm
(0.1 mm per step)
A2X0IXC034DA
If the difference in the width B is greater than the
specifications, enter a positive (+) value.
If the difference in the width B is smaller than the
specifications, enter a negative (-) value.
11. Touch "Test Copy."
12. Select the tray loading paper for the test copy.
13. Touch "2."
14. Touch "1-Sided -> 1-Sided" or "2-Sided -> 2-
Sided."
E-20
A2X0IXC038DA
A1DMIXC017DA