Switch Tip Installation; Aligning Spray; Spray - Graco 695 Operation, Parts

Switch Tip Installation

1. Perform Pressure Relief Procedure, page 8.
2. Use spray tip (A) to insert OneSeal
guard (C).
C
B
3. Insert Switch Tip.
4. Screw assembly onto gun. Tighten.
ti2710a

Aligning Spray

1. Loosen guard retaining nut.
2. Align tip guard horizontally to spray a horizontal
pattern.
3A4399A
™
(B) into
A
ti13023a
ti13024a
3. Align tip guard vertically to spray a vertical pattern.

Spray

1. Spray test pattern. Increase pressure to eliminate
heavy edges. Use smaller tip size if pressure adjust-
ment can not eliminate heavy edges.
2. Hold gun perpendicular, 10-12 in. (25-30 cm) from
surface. Spray back and forth. Overlap by 50%.
Trigger gun after moving and release before stop-
ping.
Switch Tip Installation
ti18243a
ti18242a
11