Raymarine Quantum 2 Installation Instructions Manual page 35

1. Install the Wi-Fi Analyzer app on your smart device.
2. Enable your MFDs Wi-Fi connection: (Homescreen > Set-up > Wireless connection > Wi-Fi >
Wi-Fi: On)
3. Make a note of the MFDs Wi-Fi Name (Homescreen > Set-up > Wireless connection > Wi-Fi >
Wi-Fi Sharing > Wi-Fi Name).
4. Go to the location you have chosen for your Radar.
5. Open the Wi-Fi Analyzer app on your smart device and scan available networks.
6. Establish the signal strength of your MFDs Wi-Fi network at the intended install location.
For reliable Wi-Fi performance the signal strength should be better than –75dBm, the closer the
signal is to zero the better the Wi-Fi performance will be (e.g. –40dBm is better than –75dBm).
7. If you have a weak or intermittent signal then you will need to investigate further, please refer to
the Wi-Fi location requirements guide to help establish what may be causing the problem.
8. For networks with multiple MFDs, repeat steps 2 to 7 for each MFD in your network.
Planning the installation
35