Console (Fig F); Explanation Display Functions; Explanation Of Buttons - Tunturi F40 User Manual

English

Console (fig F)

1
2
3
1. Display
2. Tablet/ book support
3. Buttons
CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is covered
with drops of sweat.
• Do not lean on the console.
• Only touch the display with the tip of your finger.
Make sure that your nails or sharp objects do not
touch the display.
NOTE
• The console switches to standby mode when
the equipment is not used for 4 minutes. If the
console is in standby mode, the display shows
the room temperature

Explanation Display functions

Time
- Without setting the target value, time will count up.
- When setting the target value, time will count down
from your target time to 0 and alarm will sound or
flash.
- Without any signal being transmitted into the
monitor for 4 seconds during workout, time will
STOP
- Range 0:00~99:59
Speed
- Displays current training speed.
Maximum speed is 99.9 KM/H or ML/H.
- Without any signal being transmitted into the
monitor for 4 seconds during workout, SPEED will
display "0.0"
RPM
- Displays the Rotation Per Minute.
Display range 0~15~999
- Without any signal being transmitted into the
monitor for 4 seconds during workout, RPM will
display "0"
Distance
- Without setting the target value, distance will count
up.
- When setting the target value, distance will count
down from your target distance to 0 with an alarm
sound or flash.
- Range 0.00~99.99
Calories
- Without setting the target value, calorie will count
up.
- When setting the target value, calories will count
down from your target calorie to 0 with an alarm
sound or flash.
- Range 0~9999.
NOTE
• This data is a rough guide for comparison of
different exercise sessions which cannot be used
in medical treatment
Pulse
- Current pulse will display after 6 seconds when
detected by the console.
- Without any pulse signal for 6 seconds, console will
display "P".
- Pulse alarm will sound when current pulse is over
the target pulse.
- Range 0-30~230 BPM

Explanation of buttons

Up (Dail)
- Increase resistance level
- Setting selection.
Down (Dail)
- Decrease resistance level
- Setting selection.
2 0