Intercharacter Delay; User Specified Intercharacter Delay - Honeywell Voyager 1250g User Manual

Intercharacter Delay

An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed between the transmission of each character of scanned data. Scan the
Intercharacter Delay bar code below, then scan the number of 5ms delays, and
the
To remove this delay, scan the Intercharacter Delay bar code, then set the number
of delays to 0. Scan the
Note: Intercharacter delays are not supported in USB serial emulation.

User Specified Intercharacter Delay

An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed after the transmission of a particular character of scanned data. Scan the
Delay Length bar code below, then scan the number of 5ms delays, and the
bar code using the
Next, scan the Character to Trigger Delay bar code, then the 2-digit hex value for a
printable character to trigger the delay (see
193).
To remove this delay, scan the Delay Length bar code, and set the number of
delays to 0. Scan the
Voyager 1250g User Guide
Save bar code using the
Programming Chart
Delay Length
Save
Programming Chart
Prefix Scanned Data
1 2 3
Intercharacter Delay
Intercharacter Delay
Save bar code using the
on page 202.
bar code using the
on page 202.
Suffix
4 5
Programming Chart
Lower ASCII Reference Table
Character to Trigger Delay
Programming Chart
on page 202.
Save
on page
on page 202.
67