User-Specified Reread Delay; Output Sequence Overview; Output Sequence Editor; To Add An Output Sequence - Honeywell Voyager 1250g User Manual

User-Specified Reread Delay

If you want to set your own length for the reread delay, scan the bar code below,
then set the delay (from 0-30,000 milliseconds) by scanning digits from the
Programming Chart

Output Sequence Overview

Output Sequence Editor

This programming selection allows you to program the scanner to output data
(when scanning more than one symbol) in whatever order your application
requires, regardless of the order in which the bar codes are scanned. Reading the
Default Sequence symbol programs the scanner to the Universal values, shown
below. These are the defaults. Be certain you want to delete or clear all formats
before you read the Default Sequence symbol.
Note: To make Output Sequence Editor selections, you'll need to know the code I.D., code
length, and character match(es) your application requires. Use the Alphanumeric
symbols from the
trigger while reading each bar code in the sequence.

To Add an Output Sequence

1. Scan the Enter Sequence symbol (see
2. Code I.D.
3. Length
Voyager 1250g User Guide
Long (1000 ms)
on page 202, then Save.
Programming Chart,
On the Symbology Charts
to apply the output sequence format. Locate the Hex value for that symbology
and scan the 2 digit hex value from the
Specify what length (up to 9999 characters) of data output will be acceptable
User-Specified Reread Delay
beginning on page 202. You must hold the
Require Output
on page 189, find the symbology to which you want
Programming Chart
Extra Long (2000 ms)
Sequence, page 59).
on page 202.
55