Turning Route Display On/Off; Deleting Route Waypoints; Deleting Routes - Furuno RP-17 Operator's Manual

8. Locate the cursor where you want to en-
ter a route point.
9. Key in waypoint number. (The buzzer
sounds if you enter a waypoint which has
not been registered.)
10.Press the [ENTER/SELECT] key.
11. Repeat steps 8-10 to complete the route.
12.Press the [MENU] key to finish.
5.5 Turning Route Display
On/Off
You may choose to display (or not) a route
as follows.
1. Press the [MENU] key.
2. Press the [1] key twice to select Video Plot.
3. Press the [5] key twice to select Route.
Route
1. Mode = Cursor
2. Speed for TTG = 10.0kt
(Route List)
No. Disp Pts
1 YES 30 1234.56 nm 12345.6H In use
s
2 YES 5 2345.67 nm 12345.6H
3 YES 0 *999.99 nm *9999.9H
4 YES
8 YES
9 YES
10 YES 0 0.00 nm
Select mode and route no. by using trackball.
Display: + Not display: -
Enter: ENT
Delete: CLR
Figure 5-5 Route menu
4. Select route number with the trackball.
5. Press the [ + ] key to display the route; the
[ - ] key to not display it.
6. Press the [ENTER/SELECT] key to regis-
ter your selection and the [MENU] key to
close the menu.
WPT No. List
Total TTG
_ _._H
Note : When a user key ([F1],[F2],[F3]) is op-
erated to register a waypoint all waypoints,
including route waypoints, are automatically
displayed. However, route waypoints are not
connected (with a line). If you want to show
the line which connects route waypoints,
open the ROUTE menu and then close it.

5.6 Deleting Route Waypoints

1. Press [MENU], [1], [1], [5], [5] to display
the Route menu.
2. Press the [1] key twice to select List.
3. Press the [ENTER/SELECT] key.
4. Select route number.
5. Press the [ENTER/SELECT] key.
6. Select route waypoint to delete.
7. Press the [CANCEL/CLEAR] key.
8. Press the [ENTER/SELECT] key. The
route data changes to reflect deletion.
9. Press the [MENU] key to finish.

5.7 Deleting Routes

1. Press [MENU], [1], [1], [5], [5] to display
the Route menu.
2. Select route number with the trackball.
3. Press the [CANCEL/CLEAR] key.
4. Press the [ENTER/SELECT] key to de-
lete the route.
5. Press the [MENU] key to finish.
5-5