Siemens SIMATIC RF300 System Manual page 46

RF300 system planning
4.2 Field data for transponders, readers and antennas
RF350R reader / ANT 30
Table 4- 12 RF350R reader / ANT 30
Diameter of the
transmission window
(L )
d
Operating distance (S )
a
Limit distance (S )
g
All values are in mm
RF380R reader
Table 4- 13 RF380R reader
Length of the
transmission window
(L )
x
Width of the
transmission window
(L )
y
Operating distance (S )
a
Limit distance (S )
g
All values are in mm
Values in brackets [ ] refer to RF380R with the MLFB 6GT2801-3AB10
The RF380R with MLFB 6GT2801-3AB10 gives the user the capability of setting the
transmission output power with the aid of the "dili" (distance limiting) input parameter. For
this, values from approx. 0.5 W to approx. 2.0 W can be set in 0.25 W increments.
Depending on the setting, the change to the transmission output power increases the
performance in the lower operating distance (low performance) or in the upper limit distance
(high performance).
The "dili" value range goes from
02 (= 0.5 W) and
05 (default value: 1.25 W) to
08 (= 2 W).
Note
A dili value setting outside of the value range of 02 to 08 leads to the default setting (05) and
does not generate an error message.
Also see Chapter Minimum clearances (Page 48) Section "Minimum distance from reader to
reader".
You can find exact information regarding the parameters in the Product Information "FB 45
and FC 45 input parameters for RF300 and ISO transponders"
(http://support.automation.siemens.com/WW/view/en/33315697).
46
RF320T RF340T
15 25
2...11 5...15
15 20
RF320T RF340T
100 115
40 50
2...30 [40] 20...70 [80]
47 [55] 90 [100]
RF350T RF360T
25
5...16
22
RF350T RF360T
120 120
60 70
35...70 [100] 40...120
105 [130] 140 [150]
RF370T
Not yet released
RF370T
135
65
35...85 [100] 25...85 [110]
125 [135]
SIMATIC RF300
System Manual, 01/2009, A5E01642529-03
RF380T
RF380T
155
75
125 [140]