Video Operations; Setting The Output Format; Switching Video; About The Screen Modes - Roland XS-1HD Owner's Manual

Video Operations

Setting the Output Format

Here's how to specify the output format as appropriate
for the devices connected to the XS-1HD.
1.
[MENU] button g "Output" g select "Format."
2.
Use the [VALUE] knob to select the output
format.
* For the output formats supported by the XS-1HD, refer to
"Output Video Formats" on the previous page.
3.
If the message "Keep output format?" appears,
use the [CURSOR] knob to select "Yes," and press
the [ENTER] button.
The output format is switched.
4.
Press the [MENU] button several times to close
the menu.
MEMO
If the screen mode is "switcher mode" (p. 15), the output
format of the VIDEO OUTPUT 4 connector is fixed at
"1080p/60 Hz. "
About frame rate
Frame rates that can be input and output are "59.94
Hz" or "50 Hz. "
You can change the frame rate in [MENU] button g
"System" g "Frame Rate. "
When inputting Computer-resolution video
The refresh rate is "60 Hz" regardless of the frame
rate.
When outputting Computer-resolution video
If the frame rate setting is "50 Hz, " the refresh rate
might be "75 Hz" depending on the output resolution.
12

Switching Video

Here's how to switch between the video input signals
and output the result.

About the Screen Modes

The XS-1HD's video output has three screen modes:
matrix, split, and switcher.
Matrix mode (next page)
Use the cross-point buttons to switch the combination
of four inputs and four outputs, and output the video.
The internal frame synchronizer allows seamless
video switching.
Split mode (p. 14)
Up to four screens of the video selected by the cross-
point buttons can be layer-composited and output.
The video of XPT 1 can also be key-composited.
Switcher mode (p. 15)
The video of the PGM side (XPT3 row) is always
output. The PST side (XPT4 row) selects the preset
video (the video that will be output next).
Use the [AUTO] button or operate the video fader to
switch the video.
* The VIDEO OUTPUT 4 connector outputs a multi-view
that lets you check the input video channels 1–4.
MEMO
The current screen mode is shown by the SCREEN MODE
indicators.
Switching the screen mode
1.
[MENU] button g "System" g select "Screen
Mode."
2.
Use the [VALUE] knob to set the screen mode to
Matrix, Split, or Switcher.
3.
Press the [MENU] button several times to close
the menu.