Verifying Fc Npv - Cisco N9K-C93180YC-FX Configuration Manual

Configuring N Port Virtualization
Step 3
Enabling Disruptive Load Balancing
If you configure additional NP uplinks, you can enable the disruptive load-balancing feature to distribute the
server traffic load evenly among all the NP uplinks.
To enable disruptive load balancing, perform this task:
Procedure
Step 1
Step 2
Step 3

Verifying FC NPV

To display information about FC NPV, perform the following task:
Procedure
Step 1
Command or Action
switch(config)# no npv traffic-map
server-interface {fc slot/port | vfc vfc-id}
external-interface { fc slot/port |
san-port-channel <number> | vfc vfc-id |
vfc-port-channel vfc-port-channel-id }
Command or Action
switch# configure terminal
switch(config)# npv auto-load-balance
disruptive
switch (config)# no npv auto-load-balance
disruptive
Command or Action
switch# show feature-set | i fcoe
Example:
switch# show feature-set | i fcoe
fcoe-npv
Purpose
To map the server interface to a
Note
different uplink, the server interface
must be shut down before configuring
the traffic map.
Removes the mapping between the specified
server interfaces and NP uplink interfaces.
Purpose
Enters configuration mode on the NPV.
Enables disruptive load balancing on the
switch.
Disables disruptive load balancing on the
switch.
8 enabled
Cisco Nexus 9000 Series NX-OS FC NPV Configuration Guide
Verifying FC NPV
Purpose
19