Verifying The Ipv4 Configuration; Configuration Examples For Ipv4; Additional References - Cisco Nexus 3000 Series Configuration Manual

Verifying the IPv4 Configuration

S e n d d o c u m e n t c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
To enable IP directed broadcasts, use the following command in interface configuration mode:
Command
ip directed-broadcast
Verifying the IPv4 Configuration
To display the IPv4 configuration, perform one of the following tasks:
Command
show hardware forwarding ip verify
show ip adjacency
show ip arp
show ip interface
show ip arp statistics [vrf vrf-name]

Configuration Examples for IPv4

This example shows how to configure an IPv4 address:
configure terminal
interface ethernet 1/2
no switchport
ip address 192.2.1.1/16

Additional References

For additional information related to implementing IP, see the following sections:
•
•
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release 5.0(3)U1(1)
2-14
Related Documents, page 2-15
Standards, page 2-15
Purpose
Enables the translation of a directed broadcast to physical
broadcasts
Purpose
Displays the IP packet verification configuration.
Displays the adjacency table.
Displays the ARP table.
Displays IP related interface information.
Displays the ARP statistics.
Chapter 2 Configuring IPv4