6235/6235i/6236i (RM-60) Disassembly/Assembly Assembly Instructions To assemble the mobile terminal, follow the "Disassembly Instructions" in reverse order. Disassembly Instructions Use the following steps to disassemble the phone. 1. Prepare the phone A. Turn the phone off. B. Gently place protective film on display (outside) to prevent scratches.
6235/6235i/6236i (RM-60) Nokia Customer Care Disassembly/Assembly 3. Remove the A-cover Rotate A-Cover from the face of phone and remove. Be careful of the header cap and retaining snaps along either side and at top. Snaps A-cover Notice the keypad does not self-retain within the A-cover and is easily lifted from position.
6235/6235i/6236i (RM-60) Disassembly/Assembly 5. Remove the Screws A. Use a screwdriver to remove the six Torx screws, in the order shown, to free the UI module. LCD Display B. Place protective film on the LCD display to prevent scratches. 6. Remove the PWB Assembly Carefully lift the PWB assembly off the B-cover.
6235/6235i/6236i (RM-60) Nokia Customer Care Disassembly/Assembly 7. Separate the LCD Display from the PWB Gently lift the LCD display off of the PWB. Be careful of the attachment point, since it is the only fixed mounting point for this assembly once the six Torx screws have been removed.
6235/6235i/6236i (RM-60) Disassembly/Assembly 9. LCD Display Disassembly A. Open the snaps (highlighted below) on both sides of the LCD frame using an appropriate tool. B. Gently remove frame, taking care not to damage it. C. Gently pry the LCD shield mounting tabs to remove the shield fro the LCD frame.
6235/6235i/6236i (RM-60) Nokia Customer Care Disassembly/Assembly 11. Remove the Volume Key A. Applying gentle pressure, push the volume key backwards, and then lift upwards to remove from the B-Cover. Snaps Note: The snaps on either side must clear the retainers.
6235/6235i/6236i (RM-60) Disassembly/Assembly 13. Remove the UHJ Sliding Cover Note the sliding UHJ cover and the relative slot/tab arrangement prior to disassembly. Slide cover so that the tab lines up with the opening slot, and then use tweezers to gently pull it away from the B-Cover.
6235/6235i/6236i (RM-60) Nokia Customer Care Disassembly/Assembly 15. Remove the Infrared Lens After the power key is removed, use tweezers to gently lift the infrared lens from its mount 16. Remove the Antenna/IHF Speaker Using tweezers, gently pry the antenna/IHF speaker assembly from the C-Cover at the sides, top, and bottom.
6235/6235i/6236i (RM-60) Disassembly/Assembly 17. Remove the SIM Cover A. Grab the C-Cover so that you can open the SIM cover. B. Rotate the cover to reveal the inside (vs. the outside back). Gently unsnap the cover from its mounts and remove.