Adjusting The Pulse Flow Setting - Invacare XPO2 Operator's Manual

Oxygen
Outlet Port
DETAIL
"A"
FIGURE 6.8 Connecting/Positioning the Nasal Cannula

Adjusting the Pulse Flow Setting

It is very important to select the prescribed level of oxygen
flow. DO NOT increase or decrease the flow unless a change
has been prescribed by your physician or therapist.
NOTE: For this procedure, refer to FIGURE 6.9 on page 32.
1. Turn On the XPO
On/Off button for approximately one second. Each time
the XPO is turned On, a brief alarm will sound. The XPO
2
pulse flow setting at power‐up will be the same flow
setting selected the last time the unit was turned Off.
2. The XPO has five pulse flow settings. Press the flow
2
selection (+ or ‐) button until your prescribed flow setting
(1 to 5) is illuminated by a blue indicator light.
FLOW SETTING
1
Part No 1160887
SECTION 6—OPERATING INSTRUCTIONS
Nasal
Cannula
CAUTION
by pressing and holding the power
2
AVERAGE PULSE VOLUME (AT 20
BREATHS PER MINUTE)
31
DETAIL "B"
15 ml
Invacare XPO2™
2