D-Link DXS-1210-10TS User Manual page 57

Click the Apply button to save your settings.
Enter instance ID 1 and click Apply to create ERPS physical ring. Then the following page will be displayed.
Click Edit Instance button to modify the ERP instance, click Show Status button to display the ERPS
physical ring's status information, or click Delete button to remove the Ethernet instance.
Click Edit Instance to modify the Ethernet Instance configuration:
Ethernet Ring Name: Enter the Ethernet ring name for the specified instance.
Sub Ring Name: Enter the sub ring name of a physical ring.
Port0: Specifies the port as the first ring port and also specifies the virtual port channel used.
Port1: Specifies the port as the second ring port and also specifies the virtual port channel used.
Description: Enter the description for the specified instance.
R-APS Channel VLAN (1-4094): Specifies the R-APS channel of ERP instance. The range is between 1
and 4094.
Inclusion VLAN List: Specifies to add or delete the inclusion VLAN group. The VLANs specified here will be
protected by the ERP mechanism.
MEL(0-7): Specifies the ring MEL of the R-APS function. The default ring MEL is 1.
Profile Name: Specifies the profile name of Ethernet Instance.
RPL Port: Specifies the RPL port used. Options to choose from are Port0, Port1, and None.
RPL Owner: Specifies to enable or disable the RPL owner node.
Active: Specifies enable or disable to active this ERP instance.
NOTE: STP and LBD should be disabled on the
ring ports before enabling ERPS.
Figure 4.82 – L2 Features > ERPS(G.8032) > ERPS - Create
Figure 4.83 – L2 Features > ERPS(G.8032) > ERPS – Edit Instance
D-Link DXS-1210 Series User Manual
51