Download Print this page
Radio Shack 21-1177 User Manual
Radio Shack 21-1177 User Manual

Radio Shack 21-1177 User Manual

Noise-cancelling dynamic cb microphone

Advertisement

Quick Links

21-1177.fm Page 1 Thursday, August 5, 1999 8:44 AM
Noise-Cancelling Dynamic CB Microphone
Your Radio Shack Noise-Cancelling CB
Microphone is designed for use with your
CB in your vehicle, where background
noise is a problem. It picks up voice fre-
quencies spoken directly into the micro-
phone and filters out background noise
from vehicles, wind, the car radio, etc.
The microphone is also ideal for a mobile
or outdoor PA system.
FEATURES
Frequency Response — optimized for
close-up vocal use.
Built-In Acoustic Filter — reduces wind
and pop noise.
2-Foot Cable with 5-Pin (DIN) Connec-
tor — for easy connection to your CB or
outdoor PA system.
Low-Impedance Operation — lets you
use your microphone with a wide range of
equipment.
INSTALLING THE
BATTERIES
You need two AAA batteries (not sup-
plied) to power your microphone. We rec-
ommend alkaline batteries, such as Cat.
No. 23-555.
Radio Shack is a registered trademark used by Tandy Corporation.
1. Push the tab on the battery com-
partment cover in the direction of
the arrow, then lift off the cover.
2. Install the batteries as indicated by
the polarity symbols (+ and –)
marked inside the compartment.
3. Replace the cover.
When the
place the batteries.
Note: The
briefly when you release the switch on
the microphone's side.
©
1995 Tandy Corporation.
All Rights Reserved.
Cat. No. 21-1177
indicator lights, re-
BATT. LOW
indicator lights
BATT. LOW

Advertisement

loading

Summary of Contents for Radio Shack 21-1177

  • Page 1: Installing The Batteries

    21-1177.fm Page 1 Thursday, August 5, 1999 8:44 AM Noise-Cancelling Dynamic CB Microphone Your Radio Shack Noise-Cancelling CB Microphone is designed for use with your CB in your vehicle, where background noise is a problem. It picks up voice fre-...
  • Page 2: Using The Microphone

    21-1177.fm Page 2 Thursday, August 5, 1999 8:44 AM MOUNTING THE CLIP HANGER You can hang the microphone on your CB’s existing mounting bracket, or use the supplied clip hanger and screws. To mount the clip hanger, use it as a tem- plate and drill two holes at the desired lo- cations on the vehicle’s dashboard.
  • Page 3 PA equipment. Important: Do not cut the microphone’s wires. If you cut any wire, you cannot obtain a refund or exchange on this product. Radio Shack will provide warranty service if you cut a wire and find the product is defective.
  • Page 4: Specifications

    Within this period, we will repair it without charge for parts and labor. Simply bring your Radio Shack sales slip as proof of purchase date to any Radio Shack store. Warranty does not cover transportation costs. Nor does it cover a product subjected to misuse or accidental damage.