2. ELECTRICAL ADJUSTMENT
2-1 Precautions
Before performing adjustments and checks clean and
●
demagnetize the entire tape path.
In general, adjustments and checks are made in the order
●
of Lch then Rch. Double REF. Nos. indicate Lch/Rch.
(Example; R11/R21)
0dB is referenced to 0.775V.
●
The AC voltmeter used in the procedures must have an
●
input impedance of 1MΩ or more.
Unless specified otherwise, adjustments and checks are
●
made in FWD direction.
2-2 Adjustment locations
2. アンプ部の調整
2-1 注意
アンプ部の調整・確認の前に、テープ走行系の消磁と清掃を
●
行なってください。
特に指定のない限り、調整はLch, Rchの順序で行なってくだ
●
さい。尚、R11/R21のように記されている回路番号は
Lch/Rchを示します。
0dBは0.775Vです。
●
測定に使用するレベル計の入力インピーダンスは1MΩ以上
●
のものを使用してください。
特に指定のない場合、調整および確認はFWD方向で行なって
●
ください。
調整個所
2-2
Fig. 2-2
−5−
TASCAM 202MKV