Troubleshooting - Radio Shack 49-2512 Owner's Manual

VCR Playback to the Monitor
To view a recorded tape through the monitor,
follow these steps.
1. Turn on the monitor and the VCR.
2. Press VCR on the monitor's front panel.
The VCR indicator lights.
ˆ
Care
Keep the monitor dry; if it gets wet, wipe it
dry immediately. Use and store the monitor
only in normal temperature environments.
Handle the monitor carefully; do not drop it.
Keep the monitor away from dust and dirt,
and wipe it with a damp cloth occasionally to
keep it looking new.
Modifying or tampering with the monitor's in-
ternal components can cause a malfunction
and might invalidate its warranty and void
your FCC authorization to operate it. If your
monitor is not performing as it should, take it
to your local RadioShack store for assis-
tance.

TROUBLESHOOTING

If your monitor is not working as it should,
these suggestions might help you eliminate
the problem. If the monitor still does not op-
erate properly, take it to your local Ra-
dioShack store for assistance.
No picture appears.
• Be sure the monitor's power is on.
• Check the connections between the
camera and the monitor. Be sure audio
and video cable connections are not
reversed and that power connections
are secure. Try all the CA jacks on the
rear apron of your monitor.
• Adjust CONT.
6
3. Begin playback on the VCR.
4. When you finish playing the recorded
tape and have turned off the VCR, press
AUTO to return to sequential camera
scanning
Image is not clear.
• Adjust CONT.
• Adjust BRT.
• Adjust V-HOLD or H-HOLD.
• Be sure the selected camera is not
pointed directly at a light source.
Cannot record to a VCR.
• Check the cable connections. Be sure
audio and
reversed.
• Be sure the VCR is set to audio/video
input and is set to record.
• Check the connections between the
camera and the monitor.
Cannot play back using the monitor.
• Check the cable connections. Be sure
the audio and video cables are not
reversed.
• Be sure the VCR is set to play.
Care
video cables are not