Siemens SIMATIC PCS 7 Service Manual page 38

Adaptations in the PCS 7 project on the ES
6.2 General adaptations
6.2.6 How to update the hardware configuration for SIMATIC PCS 7 BOX RTX and
SIMATIC PCS 7 AS RTX
The steps described below only have to be carried out for project with SIMATIC PCS 7 BOX
RTX or SIMATIC PCS 7 AS RTX implementation.
Replace the automation system in the hardware configuration of the PC station.
Requirements
● The AS version in HW Config is not up to date (Version 3.3 or older)
● The assignments of CPs to the master systems are known.
Procedure
1. Open the PC station in HW Config (SIMATIC PCS 7 BOX RTX or SIMATIC PCS 7 AS RTX).
2. Select the PROFIBUS CP to which the distributed I/O is connected.
3. Select the Edit > Master system > Disconnect menu command.
4. Select the CP.
5. Select the Edit > Delete menu command.
6. Select the "Win LC RTX" CPU in the rack in HW Config.
7. Go to the"SIMATIC PC-Station > Controller > Win LC RTX" folder in HW Config.
8. Double-click the object "V4.4".
9. Click "Yes".
10.Go to the"SIMATIC PC-Station > Controller > Win LC RTX > V4.4" folder in HW Config.
11.Select the PROFIBUS CP used (default: CP 5613).
12.Drag-and-drop the selected PROFIBUS CP to the controller slot in the station window.
13.Select the entry of the associated bus system from the "Subnet" list.
14.Click "OK".
15.Select the entry of the associated bus system from the "Subnet" list.
16.Click "OK".
17.Select the Station > Save and Compile menu command.
38
The "Insert ..." dialog box opens.
The controller is replaced.
The "Properties ..." dialog box opens.
The "Insert master system" dialog box opens.
Software update without utilization of new functions
Service Manual, 03/2012, A5E02779792-02