Figure 22
Data and power
out (to Tropos 1410)
Mount the BBU on a wood pole
1.
Secure the BBU mounting plate to the pole by threading a 1/4-inch bolt through the hole in
the clamp slot to the pole. The bolt should be at least 3 1/2 inches in length. Make sure that
the bracket is level
Connect the data and power output cable to the Ethernet port on the Tropos 1410.
2.
3.
Attach the PoE input cable either to the data and output port or to a PS079001 to the power
output cable of a TLP4820.
Note
When the PS079001 is remotely mounted, the data and power out cable supplied with the unit must be
replaced with an outdoor-rated Ethernet cable of sufficient length.
Tropos 1410 Installation Guide
Remote Mounting the BBU on a Metal Pole
BBU mounting
plate
BBU
PoE Input
from
Data in
TLP4820
or PS079001
(Figure
23).
Pole bracket
Chapter 3
48