Wood Brace Mounting; Figure 8 Wood Brace Mounting Option - ABB Tropos 1410 Installation Manual

Wood Brace Mounting

You can mount the pole bracket directly on a wood brace without using clamps, as shown in
Figure 8.
Figure 8
Mount the Tropos 1410 on a wood brace
1. Select a mounting location. You can attach the Tropos 1410 to any wood brace.
2. Attach the pole bracket to the wood brace with two 1/4-inch lag bolts that are at least 3 1/2
inches in length, making sure that the wood brace is level.
Attach the mounting bracket of the Tropos 1410 to the pole bracket with two 5/16-inch
3.
machine screws (refer to
— Insert one screw through the hole at the top of the mounting bracket to the hole at the top
— Insert the other screw through the curved slot track in the mounting bracket to the hole in
Level the mounting bracket by rotating the unit along the curved slot tracks. Tighten the
4.
screws.
To continue installing the Tropos 1410, see
Tropos 1410 Installation Guide
Wood Brace Mounting Option
1/4" lag bolt
3-1/2" minimum
Figure 5
of the pole bracket.
the middle of the pole bracket just above the clamp slot.
Wood brace
for the correct orientation):
"Connecting Power and Data Cables"
Chapter 2
on page 28.
25