G4 Setting The Dispensers; Figure 19 Automatic Dispenser Arrangement; Figure 20 Detergent Dispenser Terminal Block; Figure 21 Rinse Aid Dispenser Terminal Block - Electrolux NHT8 Manual

When the appliance is filled with water for the first time
in the day, pump "S" dispenses a rinse-aid quantity in
the boiler providing a concentration of 0,1 g/l. In order
to change this value, access the parameter  (see

G4 Setting the dispensers).

At each rinse cycle, pump "S" dispenses a rinse-aid
quantity in the boiler providing a concentration of 0,1 g/
l. In order to change this value, access the parameter
 (see G4 Setting the dispensers).
Insert the supplied hose into the rinse-aid container.
Connections for automatic detergent dispenser
(Figure 19)
O

Figure 19 Automatic dispenser arrangement

There are two holes (plugged) "O" (Ø 5mm) for introdu-
cing the detergent. These holes may be easily identi-
fied from outside by looking for the countersunk marks
on the external panel.
Inside the tank there is a hole "P" (Ø 10 mm) closed
with a plug, which may be used for mounting a liquid
detergent injector.
Electrical connections for automatic detergent and
rinse-aid dispensers.
Terminals are available on the power supply terminal
board for the electrical connection of external dispen-
sers working at 220-240 V. Max. power 30 VA.

Figure 20 Detergent dispenser terminal block

• Connect the detergent dispenser between termi-
nals 7 and 9. These connection points are live for a
set time during filling of the tank and at the start of
the wash cycle (see paragraph G4 "Setting the
O
P
R S
dispensers").

Figure 21 Rinse aid dispenser terminal block

• Connect the rinse-aid dispenser between termi-
nals 8 and 9. These connection points are live
during filling of the tank and at the end of the rinse
cycle for a set time (see paragraph G4 "Setting the
dispensers").
MANUAL ACTIVATION
Whenever the detergent containers are replaced, it
may be necessary to activate the dispensers manually
in order to fill the hoses and eliminate any air. Simulta-
neously press the buttons, as shown in the figures
below. If necessary, repeat this operation several
times.
DETERGENT DISPENSER
G4 Setting the dispensers
All operations should be carried out with the appliance
switched on, the hood open and no cycle selected.
Press the On/Off button ("A" - Table 2 "Control panel")
and Wash cycle 1 button ("G" - Table 2 "Control panel")
together for 5 seconds, to access the programming
mode and the display shows the parameter "
USr
RINSE-AID DISPENSER

".
27